Quantum Guardian QG100 Owner's Manual download pdf (Page 14)

10.7 To make your carbon monoxide alarm

tamper resistant, a locking pin has been pro-

vided in the bag with the screws and anchors.

Using this pin will deter children and others

from removing the alarm from the mounting

plate. To use the pin insert it into the hole in

the side of the alarm after the alarm has been

installed on the mounting plate (See figure 6).

Note the tamper resist

pin will have to be

removed in order to

change the battery;

this can be done easily

with a long nose pli-

ers. Using the long nose pliers pull the pin

out of the hole, it is now possible to remove

the alarm from the mounting plate.

10.8 This box contains two self-adhesive

labels. You should write the telephone num-

bers of the emergency service provider and a

qualified technician in the space provided on

the labels. Place one label next to the alarm,

and the other label near a source of fresh air

where you plan to gather after the alarm indi-

cates the presence of carbon monoxide.

11.0 ALARM SIGNALS

11.1. NORMAL OPERATION: RED LED

flashes once every 30 seconds, indicating that

the alarm is powered

11.2. ALARM CONDITION: RED LED turns

"on" for 2 seconds and "off" for 3 seconds

with 4 short beeps for 1 second and 5 seconds

of silence

11.3. FAULT CONDITION: RED LED flash-

es and beeps once every 30 seconds. Device is

not working properly and should be replaced

immediately.

11.4. LOW BATTERY: One chirp every 30

seconds. Replace battery when this signal

occurs

TAMPER RESISTANT LOCKING PIN

 FIGURE 6

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments