Quantum Guardian QG100 Owner's Manual download pdf (Page 16)

re-installing the battery,

place the alarm on the

mounting plate. Twist

the alarm in the direc-

tion indicated by the

"ON" arrow on the

alarm cover (see

Section 10.6) until it

locks in place. The alarm will beep once indi-

cating proper battery installation.

13.2 Test alarm immediately following instal-

lation and weekly for proper operation by

pushing the test button until a short beep is

heard (three seconds). Release the button.

The alarm will then test itself for proper oper-

ation and the RED LED will flash 5 times. At

completion of the self test, the alarm will

sound 2 alarm patterns (4 Beeps, pause, 4

Beeps). The alarm then resumes normal oper-

ation

13.3 The Quantum Guardian Model QG100

CO Alarm uses one (1) 9 volt alkaline battery.

A fresh battery should last for one year under

normal operating conditions.

13.4 USE ONLY THE FOLLOWING 9 VOLT

BATTERIES FOR CO ALARM REPLACE-

MENT.

Alkaline type: DURACELL MN1604,

ENERGIZER 522. These batteries are avail-

able at most local retail stores.

WARNING: USE ONLY THE BAT-

TERIES SPECIFIED. USE OF DIFFERENT

BATTERIES MAY HAVE A DETRIMENTAL

EFFECT ON THE CO ALARM. THE CON-

STANT EXPOSURES TO HIGH OR LOW

TEMPERATURES OR HIGH HUMIDITY

MAY REDUCE BATTERY LIFE.

CHECK THE BATTERY MANUFACTUR-

ERS SPECIFICATIONS FOR PROPER

OPERATING CONDITIONS.

+

-

Figure 7

!

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments